Now, the application technology of silicone has been continuously infiltrated into all walks of life, and the application and requirements of different industries for silicone products are also reflected in different aspects. For example, manufacturing from kitchen silicone supplies, mobile phone shell silicone supplies, baking silicone supplies will be used.

At the same time, in the process of producing silicone products, there are often many adverse factors affecting the production capacity, thus affecting the delivery time of delivery, leading to the loss of the factory. Since it is affected by many bad factors, we will find the reasons, improve the bad, and reduce the loss of the factory. Today, Huayang Industry will introduce the bad causes and improvement methods in production:

First, the selection of materials, the most important point in the production of silicone products is the selection of materials, the material is not selected, it will lead to the quality of the product in the subsequent production process, resulting in a series of problems such as customer refund, complaints and so on. So make sure you choose your materials well.

Second, the thickness of the produced silicone products is uneven, such as too thick, can be properly reduced mold temperature, prolong the vulcanization time.

Third, if there is a bulge, it is caused by unripening, and the vulcanization time can be appropriately increased.

Fourth, opening, opening is generally the problem of silica gel raw materials, this time to check whether there is a problem with the original village material.

Fifth, the surface of silicone products is easy to spray frost, so it is necessary to master the upper limit of several compounding agents that are easy to spray frost.

Six, the surface of silica gel products have microholes, mainly because the raw material is too much water, the raw material should be baked and then used.

Seven, silica gel products produce trapped gas, mainly related to the mold, so the mold design to consider the exhaust problem.

There are bubbles on the surface of silicone products, which can improve the temperature of the mold, the time of fluidization and the number of exhaust.

Nine, silicone products are not ripe, but also improved under the temperature and fluidization system.

We do not find reasons for customer complaints, nor do we explain them because of quality. In the production process, there are many adverse factors affecting silicone products, as long as we from raw materials to quality testing, can be layers of control, in strict accordance with the requirements of production, you can produce customers satisfied with silicone products.